Why does the software close once the scheduled macro runs?

[sylar]

When I schedule a macro to run, it closes the application after it has run successfully. Is this because I am using a trial version of your software at this time? I would expect the actual software to remain open (launched) after each run so that it could run at the next scheduled time. Please verify if this is a feature/issue with the trial version only.

[navneet.soni]

I don't think this is a feature issue with the software. The next time that the macro is scheduled to run the application will be launched automatically & then close after the macro ends.

[navneet.soni]

You can remove /u from scheduled command (in Control Panel) in order to prevent the application from getting unloaded after the macro runs.