Macro no longer recognizing window title

[Marcus]

I have two macros that have been running for over a year. A week and half ago, they stopped working. The error I get is that it can find window named ...
This is for an If Window Exists block. If I try to redefine that step, even after refeshing the window list, the window with the defined name shows up gain as an option. So the question is, why is it failing and why do I get the error since it's part of the IF EXISTS command.

I even went out on and obtained a Windows Title Changer to help me inspect the title of the window. It matched what was defined in Workspace Macro Pro so it would seem the title is correct.

I'm stumped.

[forumsupport]

Hello,

Can you please try this,

. Copy the entire contents of macro using keystrokes, Ctrl+a followed by Ctrl+c.
.Then go to Tools->Macro Editor to open a blank macro editor.
. Paste the contents using Ctrl+v.
. Now, open the window in question.
. Edit the command in question and save.
. Edit 'If Window Exists' command and increase the delay time of field, 'How long would you like to wait for this condition to be true' and save.
. Save the macro.

Hope that helps.

[Marcus]

I tired the suggested solution and it did not work. I am still getting the same error. Any other suggestions?

Not to put too fine a point on it, but this set back is cancelling the benefit for using this tool - the two macros I have written are the whole purpose for purchasing this product. If a solution or fix is not forth coming, I will be forced to look for alternative solutions.

Mark

[forumsupport]

Hello Mark,

Can you please upload the macros in question and the error screenshot so we can look into it and suggest viable solution?