Having to set user profile to power user to run

[joe1970]

I am using both Launch and go and workspace macro pro to launch a program and shut it down using nothing but a scanner. It works fine under my profile with admin rights. When I log in as a normal "authenticated user" I get an error stating that I must first log in as administrator and then it will work on all accounts. The only way I have found to resolve this so far is to elevate this account to "power user" however this is a service account and I really don't want to give them that much access. Any suggestions are welcome.




Joe T

[forumsupport]

Hello Joe,

You can overcome this issue by following below mentioned steps.

1) Login with Administrator account.
2) Provide proper rights (Read and Write) to 'All Users' folder under C:\Documents and Settings.
3) Now, login with Non-Administrative account and try opening the software again.